The ventilation kits we market come from several sources and are designed for Cessna, Piper and Mooney aircraft. The Cessna ventilation kits include Ventube™ kits and Airflow Enhancement Kits. The kit for Mooneys is a Cool Flow Solar Cabin Ventilator which extracts hot air from your airplane as it sits on the ramp. The ventilation kits for Piper include the Cool Flow Solar Cabin Ventilaton kits and a set of interior Ventilation Louvers.

Cessna Ventube™ Kits

The Cessna Ventube™ kit will give you and your passengers greater comfort by controlling the air flow and reducing the vent noise inside your Cessna cabin. It works simply and reliably to control air direction and flow and is designed to replace your Cessna's original pull-out vent-tube. Each Ventube™ is a plastic tube with a cap. Turning the interior cap clockwise pulls the cap against an O-ring seal to close the vent. Airflow is accomplished by extending or retracting this interior tube. A simple twist of the interior tube controls air direction. The locking cap, friction rings and coins, tolerance between the tubes, and the O-ring seal work together to provide quiet and controlled air flow. The kit fits all single engine Cessnas through the 210F Model and the Cessna 305. The color is tan and the price is $75 per set.

Cessna Airflow Enhancement Kit

The Airflow Enhancement Kit improves the comfort of pilot and passengers by increasing cabin air flow and reducing inlet air noise and leakage. It works with the above Ventubes™ to give you better ventilation inside the cabin. The kit components consist of the Cabin and Fuselage Exit Vents. The Cabin Exit Vent (CEV) is a round aluminum louvered grill that is installed behind the seats in rear of the baggage compartment in a non-structural area and allows air to exit the cabin into the rear fuselage area. The Fuselage Exit Vent (FEV) is an aluminum, louvered, round grill that is installed by replacing an existing non-structural inspection plate in the rear fuselage area and allows air to exit to the outside of the aircraft. The grill is equipped with a screen to deter insects and water from entering the rear fuselage area. The approximate installation time is 2 hours for the CEV and 30 minutes for the FEV. The kit sells for $50.

Mooney and Piper Cool Flow Solar Cabin Ventilator

The Cool Flow Solar Cabin Ventilator extracts hot air from your plane continuously, as long as the sun shines on it. It changes the inside cabin air several times each hour, removing excess heat and moisture. It is beautifully constructed of long lasting and tough materials, and fits securely into your pilot's vent window with no tools and no problems. You must remove it before flight. It provides the following benefits:

1. Keeps cabin relatively cool on very hot days
2. Keeps moisture from condensing inside the cabin and causing mildew
3. Helps protect your radios from corroded contacts and heat induced problems
4. Carries a 100%, 90-day money back guarantee
5. Sells for only $129

Piper Ventilation Louvers

These louvers are chrome plated and are for Piper Aircraft Models PA28, PA32, and PA34. The louver's over all outside dimensions are 4.94"W x 1.53"H and should replace most OEM louvers. The louvers come with a bezel hinged inside the louver to direct the flow of incoming air. The louver and bezel are sold as a set for customer convenience at a price of $15.