We are marketing two types of interior lighting systems for aircraft: Nulite Instrument Panel Lighting System and Ashlight Large and Small Modules.

Nulite Instrument Panel Lighting System

Nulites are a revolutionary lighting system for aircraft instruments. They have a special bezel that focuses light toward the instrument, preventing light from reflecting into the pilot's eyes. Nulites reduce glare and "hotspots" by concentrating 60% of the light on the upper half of the instrument.

The bulbs come with a 16,000 hour life expectancy. All Nulite products carry a FAA/PMA certificate and only require a log book entry by any certified person. No special tools or equipment are required and they can be installed by anyone in just a few minutes. Nulites can be wired to any existing dimming system without the need for extra circuits, inverters, or remote boxes.

Nulites are manufactured to fit all standard 2 1/4 and 3 1/8 inch round instruments. Different instruments have knobs or adjustment points and different models of Nulites are available to accommodate the adjustment knobs. Nulite part numbers describe the size, voltage, and special features needed to fit all round instruments. A typical Nulite part number is: LW3014A, where LW = Light Wedge, 30 = Size (3 1/8"), 14 = Voltage, and A = Location of Cutout (Lower Left Hand Cutout as seen from the pilot's viewpoint).

When ordering, please specify the following information:

1. Choose Size (2 1/4" or 3 1/8" round instrument)
2. Choose Voltage (14-, 28-, or 5-Volt)
3. Choose Instrument Cutout Location (as seen from pilot's viewpoint)
   • -A : Indicates lower left-hand cutout
   • -B : Indicates lower right-hand cutout
   • -AA : Indicates special cutout on left side, designed for Altimeters
   • -AB : Indicates special cutouts on left-hand and right-hand side
   • -V : Indicates special cutout on left-hand side for VSI
   • -N : Indicates no cutout

Ashlight Large and Small Modules

The Ashlight has been designed and tested by pilots and is a "must have" device. The super-bright red LED lights provide the ultimate in hands-free cockpit lighting at the location of your existing ashtray with the flip of a switch. The Ashlight is designed with a stainless steel spring that duplicates the original ashtray clip for easy snap-in installation on standard OEM large or small ashtray openings. The large Ashlight dimensions are 5"W x 2.5"H. The small Ashlight dimensions are 3"W x 2"H. Both Ashlight Modules have the following features:

1. Solid State (Light Emitting Diodes) LED Construction
2. Snap-in Convenience
3. Installation in Seconds
4. Four Ultrabright LED's
5. Fresnel Lens Light Diffusion
6. 2 AAA Batteries Provide Over 24 Hours Continuous Use (Not Included)
7. No STC Required
8. Fits Most OEM Large or Small Ashtray Openings
9. Solid Aluminum Faceplate
10. Stainless Steel Retaining Spring